Hay & Forage Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
253 Posts
I am not familiar with your piece of equipment but I repair all kinds and I would find a piece of cold roll or hot roll that fits snug in the pipe 6 or 8 inches long drill 4 holes on each side of the break put the cold roll inside of the pipe use the holes you drilled to anchor the cold roll slide the other piece over it and use the holes you drilled to align it then put a couple hot passes around where the break was and it will be much stronger than the pipe was to start with. Use about a 5/16" bit. I would also see if I could find the problem first it may of not been lined up with the other arms as in low.
 
1 - 1 of 1 Posts
Top