Hay & Forage Forum banner
1 - 1 of 1 Posts

·
Senior Member
Joined
·
2,826 Posts
New Holland does not tighten the knotters frames where the pins are. I have not seen this to be a problem, but I do weld the notches in the frame mount if they get too deep.

There is no spring on the twine holder spring bolt. The spring you are referring to is the one shown below the twine holder bolt.

The twine holder is probably worn out or the flat spring may have a crack. Remove the flat spring and rotate the knotter frame up. With the flat spring removed you can move the twine holder out of the twine disc. The twine holder should have a continuous arc with not notches or shoulders. Replace the twine holders and the flat spring.

Baling too tight can also cause the twine to pull out of the twine disc, but probably the twine holder..
 
1 - 1 of 1 Posts
Top