Hay & Forage Forum banner

1 - 4 of 4 Posts

·
Junior Member
Joined
·
40 Posts
Discussion Starter · #1 ·
Is there anyone that can give me some good advice on putting this roller back in? I had a bearing go out and the holder broke. With the tension off the belts should I be able to rock that down to get to the bolt that holds the bearing holder? I see no hole in the rear gate to get to the bolts.
 

·
Senior Member
Joined
·
2,499 Posts
Go to my pinned thread at the top of the machinery forum, My NH Repair etc. The first post is a table of contents for the posts in that thread. Under Round Balers the first post link listed is for the removal of the takeup arm rolls.
 

·
Junior Member
Joined
·
40 Posts
Discussion Starter · #3 ·
Go to my pinned thread at the top of the machinery forum, My NH Repair etc. The first post is a table of contents for the posts in that thread. Under Round Balers the first post listed is for the removal of the takeup arm rolls.
Thank you! That has had me in a tizzy for 2 days my friend.
 

·
Junior Member
Joined
·
40 Posts
Discussion Starter · #4 ·
Big thanks to Mike Again. The 664 is back to work .Your step by step instructions made things so much easier. About a 3 hour job I would say. I had a service hose made. to make it a lot easier. I never knew that port was there.

Thanks again!
 
1 - 4 of 4 Posts
Top