i have found a really nice 2555 john deere that has 2,400 hours. It has a cab, Hi low trans, loader, everything. It is all original and has been barn kept its whole life. But my problem is I was looking for a 2755 because I needed the extra 10 horsepower. My understanding is the 2555 and 2755 use the same exact engine and turbo, what could be done to the 2555 to squeeze 10 more horsepower out of it?
jd 2555
20156point7
41 - 60 of 107 Posts
Joined
·
603 Posts
Looks like a great find. Enjoy!
Joined
·
535 Posts
Self leveling loader too. Sweet.
Joined
·
5,041 Posts
What has it been used for?
Joined
·
102 Posts
My only complaint so far is on the road it vibrates really bad im hoping it's the tires but I don't really know.
Joined
·
9,579 Posts
Wow, that is one beautiful tractor......a fine specimen indeed!
Congrats....if ya ever get a hankering to get a "new"
......I'll take if off your hands in a minute
Don't see many like that........
Ok.....I can't stand it.....what did ya have to pay for that baby?
Congrats....if ya ever get a hankering to get a "new"
......I'll take if off your hands in a minute Don't see many like that........
Apparently not a whole lot.....
Ok.....I can't stand it.....what did ya have to pay for that baby?
Joined
·
102 Posts
Paid 29500 for it, probably too much but I couldn't pass it up its really hard to find them in this condition and original
Joined
·
5,041 Posts
Sounds like you got a good deal on that one. Amazing what some things are capable of when taken care of.
Joined
·
102 Posts
Where exactly is the fuse box located at?
Joined
·
6,447 Posts
Under face of RH side of dash. Face snaps off dash. Check continuity on printed circuit board(parts key 1)
Attachments
Joined
·
102 Posts
The reason I ask is because the tractor won't come out of 4wd. I got under it and found there is a broken wire on the side of the solenoid on the bottom of the transmission and I can't find where the wire goes.
Joined
·
9,579 Posts
Ifn I wuz you, and I'd certainly like to have the tractor
, I would get me a service manual and operators manual......always paid dividends for me anyway.
Joined
·
3,874 Posts
My cousin has a 2355 and that wire would come unplugged from the solenoid. We never had it to break. It would pull off if we were brush cutting. We would know then it was unplugged because it would not come out of 4 WD.
Is the wire long or does it look broken? If broken you should be able to find the other end. If long, it likely pulled lose from the other end.
Joined
·
535 Posts
Wire might run up rh side of trans case to top under cab floor. If remove cab floor might be a round plug there with other wires for transmission.
Joined
·
102 Posts
tracked down the wire under the floor and i have to get another wire tomorrow to run to the solenoid, so im hoping that will fix that. also, where is the best place to mount the bale monitor in the cab because i got to looking and I don't see anywhere to mount the bracket. I also don't see a port where I can plug in the monitor.
41 - 60 of 107 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
