Hay & Forage Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Stack sets up ok but then the table hardly will return to lower position. I removed the hose to the bottom of the cylinders at the control valve looking for a blockage. When running the pump and control valve in lower position, got heavy flow from control valve port, seems like its working against itself. Wasn't expecting hardly and oil from control port. Any ideas are appreciated.
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #5 ·
Got it fixed, I hope. Finally pulled the control valve off, old hay was packed into return spring. couldn't see because of a cover over the spring to keep hay out.
 
1 - 6 of 6 Posts
Top