If you can see a radius on the shaft where the washer would go, then there is no washer there. If it appears the shaft makes a sharp 90 degree to the shoulder a washer is there. The first washer must have a chamfer on one side to match the radius cut into the shaft at the shoulder.
The gold washer appears to be too thick. The parts manual shows a 1 mm thick washer after the chamfered washer. A second 1 mm washer goes on after the bearing is installed.
The gold washer appears to be too thick. The parts manual shows a 1 mm thick washer after the chamfered washer. A second 1 mm washer goes on after the bearing is installed.
