Hay & Forage Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Hi Mike I got the drive roller shaft repaired and put back together .I lost the bolt that goes in the end of the shaft that holds the sprocket on could you give me the dimensions I'll just pick one up at the local hardware thanks again for your help mike.
 

·
Senior Member
Joined
·
2,899 Posts
The parts book says 10 x 20 mm. Grade 8.8. In your original post you said something about a large gap between the shaft and the sprocket face. A 20mm bolt is about 3/4”, but if you still have a large gap you might want to get a 25mm bolt. Just make sure the bolt does not bottom out.
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
The parts book says 10 x 20 mm. Grade 8.8. In your original post you said something about a large gap between the shaft and the sprocket face. A 20mm bolt is about 3/4”, but if you still have a large gap you might want to get a 25mm bolt. Just make sure the bolt does not bottom out.
Thanks Mike
 
1 - 3 of 3 Posts
Top