Search Results for ‘hydraulic’

My case pressure line for the header let go. It feeds in to the space under the floor and above the shields. I need to disconnect the old hose but I cant get my head in there anywhere to see what I am doing. How the heck do you access these lines? Do I need to drop the shields? Seems like...

Hi all, Hoping that someone out there might be able to help me figure out what's wrong with my tractor. I have a TN65 that lost all hydraulic power. No power to the FEL, the remote hydraulic, or the lift arms. The issue is intermittent - occasionally it will work, then I don't have anything for...

The mower bed doesn't lift fully on the left side. The mower has two hyd cylinders, 2 1/4" dia. on the right and 2 1/2 " on the left. The left side won't fully retract, even when I disconnect it from the mower and manually try to get it retracted. With both disconnected, the cylinders extend...

Hi All .. New guy. Hope im in the right spot to post... So All hydraulics and drive went out on the 2290 tractor.. We have taken out the main drive shaft and the bevel gear on the main shaft coming from the front We did this All from the rear without removing cab and splitting tractor.. Now...

Trying to see if someone is running this combo. I just picked up a red Hoelscher 10 bale on edge accumulator that I've hooked up to my Kubota M5. Discussions with the Kubota folks indicate the Kubota is an "open center" hydraulic system and I currently have the accumulator set up as a "closed...

Hello- Where can I find the cheapest RH Remote Breakaway for my John Deere 1020? Don't have time to rebuild. Thanks

I had to change out a belt roller and had to bleed off the pressure on the density cylinders in order to remove the cylinder pins. Now after the new roller was installed I do not get any pressure to the pressure control valve. I have loosened all of the JIC fittings at both cylinders and open...

I have seen and worked on John Deere equipment that had failed prematurely because of the hydraulic oil choice. The problems I have witnessed is friction material flaking or the bonding failing between the friction material and the metal plate that it"s bonded to. Of course John Deere says only...