2 replies to this topic

[Ron S]

I have a 1983 Ford 6610 with one rear remote. My loader uses the remote. I run a wood splitter and have to disconnect the loader to run the splitter which can be a pain if I want to move the tractor. Is there a way I can add a Power Beyond like the JD's?

Thanks,

[chevytaHOE5674]

10 series should be a closed center load sense valve. Easiest way is buy a factory 2 spool 10 series CCLS remote valve and switch yours out.

Or you can feed a diverter valve from your factory valve and use it to select where the hydraulic oil is going.

Or you can T into the pressure line and add another CCLS valve, you will need a return line to the sump, and add a shuttle T to the load sense line.

I suspect you will find these options get pricey.

[chevytaHOE5674]

Or I'm assuming your single rear remote valve is feeding an open center 2 spool valve for the loader? Then you snap the remote lever into detent or tie it open?

If so you could get a 3 spool valve for the loader and use one of those spools for your splitter.