John Deere 4020 clutch issues - Page 2 - Tractor Talk - HayTalk - Hay & Forage Community - Page 2

Jump to content




Photo

John Deere 4020 clutch issues


  • Please log in to reply
21 replies to this topic

#21 TJ Hendren

TJ Hendren

    Advanced Member

  • Members
  • 380 posts
  • LocationN.E. Okla

Posted 21 February 2021 - 08:54 AM

TJ

When you state RS seals I'll guess you're referring to L/D shaft seals located in lower trans case. If I'm correct there has been a major improvement in L/D shaft seals in the last few yrs. Have you tried the bushings with a groove that o-ring fits into made by Bolings Machine shop?

Yes Jim, the load shaft. I also ordered a new shaft as I'm pretty sure it is the original shaft. This time when they went the whole 10 gallons went out in 10 minutes. This is the first time i have heard of the Bolings bushings and i will check into that before i do the fix. Thanks a lot. T.J.



#22 Farmineer95

Farmineer95

    Senior Member

  • Members
  • 523 posts
  • LocationWiscinsin

Posted 21 February 2021 - 10:00 PM

Before you install the shaft, be sure to clean the drawbar support really well where the shaft slides in. Any dirt/crud around the hole dragging along on the shaft can cause future leaks.
  • TJ Hendren likes this




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

× Sponsors