I have an 8330 case mower conditioner and I cannot get the head to sit on the ground. It does not seem to go low enough so that the skids take the weight. I have raised the skids, and adjusted the lift cylinder. Seems to stop on something with the knives about 4 or 5 inches off the ground. Any help on this would be appreciated.
Sponsors
Recent Topics
-
Need some advise-New tractor purchaselongmeadow farm - Today, 02:52 PM
-
Bermuda to "Stimmy"?Jake Nichols - Today, 09:05 AM
-
Spraying a bull for horn fliesTexasmark - Today, 08:00 AM
-
Levees-Good idea, except....rjmoses - Today, 06:22 AM
-
My new purchaseFarmerCline - Today, 12:46 AM
case 8330 mower conditioner Head Won't Sit on Ground
Started by
sooner
, Jul 09 2012 05:53 AM
2 replies to this topic
#2
steve in IN
-
- Members
- 175 posts
Junior Member
- Location (recommended)Mill Creek,IN southewst of South Bend
Posted 09 July 2012 - 09:36 PM
Try bleeding the cylinders. Also try new tips on the hoses. Something else to look at although I doubt it is your problem but look at your header float springs. I have had all these problems in the past. Good luck
#3
Iowa hay guy
-
- Members
- 229 posts
Hay Master
Posted 09 July 2012 - 11:45 PM
you might lift it up all the way and hold it to bleed the cylinders as these are a master slave in a series and if they leak down it will mess up or your float springs are too tight and its not letting it all the way down
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
